A fixture refers to anything in a home that has water flowing to it. A toilet, a sink, a hot water tank, a dishwasher, a bathtub; these are all examples of plumbing fixtures. Plumbers know the importance of keeping our fixtures operating like they should. Blockages, clogs, back flow issues and drainage are all things that a water softener at fixing on a daily basis. Water not moving around as it should poses problems in all areas of a home. Having an issue with water leaving your home can be disastrous as water finds its own level and will back up and possibly spill out, causing a major mess and potentially a lot of damage. Water not going into your home properly causes problems within the pipes and then in turn within the appliances and fixtures that use that water to operate.
Turn off the water to the water line repair heater or if the valve is not working turn off the water to the house. If the valve is not working it will need to be replaced. In a future article we will discuss how to replace your valve.
Leaks can occur anywhere in your reverse osmosis water filter system. If this ever occurs, check the source of the leak. It may be from the hoses, fittings and the valves. Most of the time, some kind of tightening might be necessary. So make sure to securely tighten the fittings. If this does not work, you may need to replace the filter itself, however that might take a bit more work.
Once you have disconnected the tank remove it from your work space. Do a thorough measurement of the remaining pipe for reference when you go to the hardware store. I will be honest with you, you might need to make a few trips back to the store. Once you get the new tank, slide it into place to line up the plumbing.
Check that your plug holes and waste outlets are clear of hair and solidified soap also check the "U" bends or traps under your sinks for potential blockages. Occasionally pour boiling water line repair down your sinks and shower wastes not forgetting the washing machine trap. Look outside too for any weeds or leaves that may be blocking gutters, gully's and waste outlets.
I bought a new kitchen sink from a brand name building supply company and hired a plumber to install it. After he had left and I filled up my new sink to wash my first load of dishes in it, I noticed the water level had dropped. You wouldn't want to feel my shock and imagine the angry words that came out of my mouth! I couldn't believe that I had spent $300.00 on a brand new sink that couldn't hold water!
Is your garbage disposal clogged, but it is turning ok? This may be due to a blockage in the pipe. If you look at the pipe work under your sink you will see that the disposal is connected to a pipe that should join to a U bend and providing it was installed correctly it should have a connector that can be undone. If you undo this connector the pipe will pull away and generally this is where most blockages occur. Remove the blockage and reconnect the pipe.